Suzuki GSX1300R - Repair Instructions; Heated Oxygen Sensor (HO2 S) Removal and Installation; Heated Oxygen Sensor (HO2 S) Inspection; PAIR Reed Valve Removal and Installation

1B-9 Emission Control Devices:
Repair Instructions
Heated Oxygen Sensor (HO2S) Removal and
Installation
B815H21206001
Removal
WARNING
!
Do not remove the HO2 sensor while it is hot.
CAUTION
!
• Be careful not to expose the HO2 sensor to
excessive shock.
• Do not use an impact wrench when
removing or installing the HO2 sensor.
• Be careful not to twist or damage the
sensor lead wires.
1) Remove the right side cowling. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)”.
2) Disconnect the HO2 sensor coupler (1).
3) Remove the HO2 sensor (2).
Installation
Install the HO2 sensor in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
Do not apply oil or other materials to the
sensor air hole.
• Tighten the HO2 sensor (1) to the specified torque.
Tightening torque
HO2 sensor (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
Heated Oxygen Sensor (HO2S) Inspection
B815H21206002
Refer to “DTC “C44” (P0130/P0135): HO2 Sensor
(HO2S) Circuit Malfunction in Section 1A (Page 1A-
102)”.
PAIR Reed Valve Removal and Installation
B815H21206003
Removal
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)”.
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)”.
3) Disconnect the PAIR hoses (1) and remove the PAIR
reed valve covers (2).
1
2
I815H1120008-01
(a)
1
I815H1120009-01
1
2
I815H1120010-01