Suzuki GSX1300R - Fuel Level Gauge Inspection; Speedometer Inspection; Speed Sensor Removal and Installation

9C-6 Combination Meter / Fuel Meter / Horn:
Fuel Level Gauge Inspection
B815H29306008
Inspect the fuel level gauge in the following procedures:
1) Remove the fuel pump. Refer to “Fuel Pump
Disassembly and Assembly in Section 1G (Page 1G-
12)”.
2) Measure the resistance at each fuel level gauge in
float position. If the resistance is incorrect, replace
fuel level gauge with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
3) Install the fuel pump. Refer to “Fuel Pump
Disassembly and Assembly in Section 1G (Page 1G-
12)”.
Speedometer Inspection
B815H29306009
If the speedometer, odometer or tripmeter does not
function properly, inspect the speed sensor and the
coupler connections. If the speed sensor and coupler
connections are OK, replace the combination meter unit
with a new one. Refer to “Combination Meter Removal
and Installation (Page 9C-2)”.
Speed Sensor Removal and Installation
B815H29306010
Removal
1) Remove the left side cowling. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)”.
2) Disconnect the speed sensor lead wire coupler (1).
3) Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the speed sensor mounting bolt (1) to the
specified torque.
Tightening torque
Speed sensor mounting bolt (a): 6.5 N·m (0.65
kgf-m, 4.7 lb-ft)
• Route the speed sensor lead wire. Refer to “Wiring
Harness Routing Diagram in Section 9A (Page 9A-5)”.
Float position Resistance
Full “a” 11 – 13 Ω
Empty “b” 130 – 135 Ω
“a”: 241.2 mm (9.50 in) “b”: 55 mm (2.17 in)
“a”
“b”
I815H1930013-01
1
I815H1930014-01
2
I815H1930015-01
(a)
1
I815H1930016-01