Suzuki GSX1300R - Side-Stand Removal and Installation; Specifications; Tightening Torque Specifications; Special Tools and Equipment

Body Structure: 9E-5
Side-stand Removal and Installation
B815H29506006
Removal
1) Support the motorcycle with a jack or wooden block.
CAUTION
!
• Do not support the motorcycle with the exhaust pipes.
• Make sure that the motorcycle is supported securely.
2) Remove the side-stand as shown in the side-stand construction. Refer to “Side-stand Construction (Page 9E-3)”.
Installation
Install the side-stand as shown in the side-stand construction. Refer to “Side-stand Construction (Page 9E-3)”.
Specifications
Tightening Torque Specifications
B815H29507001
NOTE
The specified tightening torque is also described in the following.
“Body Frame Construction (Page 9E-1)”
“Front Footrest Bracket Construction (Page 9E-2)”
“Side-stand Construction (Page 9E-3)”
“Pillion Footrest Bracket Construction (Page 9E-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B815H29508001
NOTE
Required service material is also described in the following.
“Side-stand Construction (Page 9E-3)”
“Footrest Construction (Page 9E-4)”