1B-17 Emission Control Devices:
2) When air is blown into the fuel shut-off valve with its
side “A” positioned sideways, the air cannot pass
through to the canister side. If the fuel shut-off valve
operates otherwise, it must be replaced.
WARNING
!
Gasoline and gasoline vapor is toxic. A small
amount of fuel remains in the fuel shut-off
valve when checking it. Do not swallow the
fuel when blowing the fuel shut-off valve.
Specifications
Service Data
B815H21207001
FI sensors
Tightening Torque Specifications
B815H21207002
NOTE
The specified tightening torque is also described in the following.
“Exhaust Emission Control System Description (Page 1B-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
“A”
I823H1120038-02
Item Specification Note
HO2 sensor heater resistance Approx. 8 Ω at 23 °C (73 °F)
HO2 sensor output voltage
0.3 V and less at idle speed
0.6 V and more at 3 000 r/min
PAIR control solenoid valve
resistance
20 – 24 Ω at 20 – 30 °C (68 – 86 °F)
EVAP system purge control
solenoid valve resistance
Approx. 32 Ω at 20 °C (68 °F) E-33 only
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
HO2 sensor 25 2.5 18.0 )(Page 1B-9)
PAIR reed valve cover bolt 11 1.1 8.0 )(Page 1B-10)
To Next Page
Loading...
