Suzuki GSX1300R - Repair Instructions; ECM Removal and Installation; CMP Sensor Inspection; CMP Sensor Removal and Installation

Engine Electrical Devices: 1C-2
Repair Instructions
ECM Removal and Installation
B815H21306001
Removal
1) Remove the front seat. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
2) Disconnect the couplers and remove the ECM (1).
Installation
Install the ECM in the reverse order of removal.
CMP Sensor Inspection
B815H21306002
Refer to “DTC “C11” (P0340) CMP Sensor Circuit
Malfunction in Section 1A (Page 1A-28)”.
CMP Sensor Removal and Installation
B815H21306003
Removal
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)”.
2) Disconnect the coupler (1) and remove the CMP
sensor (2).
Installation
Install the CMP sensor in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
When installing the CMP sensor, make sure
to clean the sensor surface.
• Tighten the CMP sensor bolt (1) to the specified
torque.
Tightening torque
CMP sensor bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
CKP Sensor Inspection
B815H21306004
Refer to “CKP Sensor Inspection in Section 1H
(Page 1H-10)”.
CKP Sensor Removal and Installation
B815H21306005
Removal
1) Remove the left side cowling. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)”.
2) Remove the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-6)”.
3) Remove the CKP sensor (1) along with generator
stator (2).
1
I815H1130001-01
1
2
I815H1130002-01
(a)
1
I815H1130003-01
2
1
I815H1130004-01