Lighting Systems: 9B-11
Passing Light Switch Inspection
B815H29206022
Inspect the passing light switch in the following
procedures:
1) Remove the left upper panel. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the passing light switch for continuity with a
tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the passing light switch inspection,
reinstall the removed parts.
Dimmer Switch Inspection
B815H29206023
Inspect the dimmer switch in the following procedures:
1) Remove the left upper panel. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the dimmer switch for continuity with a tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the dimmer switch inspection, reinstall
the removed parts.
1
I815H1920041-01
PUSH
Position
Color
OY
I815H1920042-01
1
I815H1920043-01
Position
Color
WY O
HI
LO
I815H1920044-01
To Next Page
Loading...
