Emission Control Devices: 1B-10
4) Remove the PAIR reed valves (3).
Installation
Install the PAIR reed valve in the reverse order of
removal. Pay attention to the following points:
• Apply thread lock to the bolts and tighten them to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
PAIR reed valve cover bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
PAIR Control Solenoid Valve Removal and
Installation
B815H21206004
Removal
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)”.
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)”.
3) Disconnect the PAIR control solenoid valve coupler
(1) and PAIR hoses (2).
4) Remove the PAIR control solenoid valve (3).
Installation
Install the PAIR control solenoid valve in the reverse
order of removal. Pay attention to the following point:
• Connect the PAIR control solenoid valve coupler and
PAIR hoses securely. Refer to “Exhaust Emission
Control System Description (Page 1B-3)”.
3
I815H1120011-02
(a)
(a)
I815H1120012-01
1
3
2
I815H1120013-01
To Next Page
Loading...
