Ignition System: 1H-11
CKP Sensor Resistance
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)”.
2) Disconnect the CKP sensor coupler (1).
3) Measure the resistance between the lead wires and
ground. If the resistance is not within the standard
range, replace the CKP sensor with a new one.
Refer to “CKP Sensor Removal and Installation
(Page 1H-11)”.
Tester knob indication
Resistance (Ω)
CKP sensor resistance
180 – 280 Ω (Bl – Green)
∞ Ω (Bl – Ground)
4) After measuring the CKP sensor resistance, connect
the CKP sensor coupler.
5) Reinstall the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
CKP Sensor Removal and Installation
B815H21806005
Refer to “Generator Removal and Installation in Section
1J (Page 1J-6)”.
Engine Stop Switch Inspection
B815H21806006
Inspect the engine stop switch in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the left upper panel. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
3) Disconnect the right handlebar switch coupler (1).
4) Inspect the engine stop switch for continuity with a
tester.
If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
“Handlebar Removal and Installation in Section 6B
(Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
5) After finishing the engine stop switch inspection,
reinstall the removed parts.
1. CKP sensor coupler 2. CKP sensor
1
I815H1180011-01
2
1
I815H1180024-01
1
I815H1180010-01
O/B O/W
Color
Position
OFF
RUN
()
()
I815H1180012-01
To Next Page
Loading...
