Suzuki GSX1300R - Clutch Master Cylinder Assembly Removal and Installation

Clutch: 5C-7
Clutch Master Cylinder Assembly Removal and
Installation
B815H25306008
Removal
1) Drain clutch fluid. Refer to “Clutch Fluid
Replacement (Page 5C-4)”.
2) Disconnect the clutch lever position switch lead
wires (1).
3) Place a rag under the clutch hose union bolt (2) to
catch any spilt brake fluid.
4) Disconnect the clutch hose by removing the clutch
hose union bolt (2).
5) Remove the clutch master cylinder assembly.
Installation
Install the clutch master cylinder in the reverse order of
removal. Pay attention to the following points:
• When installing the clutch master cylinder (1) onto the
left handlebar (2), align the master cylinder holder’s
mating surface “A” with the punch mark “B” on the
handlebar and tighten the upper holder bolt first. Refer
to “Handlebar Construction in Section 6B (Page 6B-
2)”.
Tightening torque
Clutch master cylinder holder bolt (a): 10 N·m (
1.0 kgf-m, 7.0 lb-ft)
2
1
I815H1530010-02
I815H1530011-01
“C”: “UP” mark “a”: Clearance
1
2
“A”
“B”
(a)
I815H1530012-02
“C”
“a”
“A”
“B”
(a)
(a)
1
2
I815H1530013-04