Suzuki GSX1300R - Starter Button Inspection; Specifications; Service Data; Tightening Torque Specifications

1I-13 Starting System:
Starter Button Inspection
B815H21906012
Inspect the starter button in the following procedures:
1) Remove the left upper panel. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
2) Disconnect the right handlebar switch coupler (1).
3) Inspect the starter button for continuity with the
tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
“Handlebar Removal and Installation in Section 6B
(Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the starter button inspection, reinstall
the removed parts.
Specifications
Service Data
B815H21907001
Electrical
Unit: mm
Tightening Torque Specifications
B815H21907002
NOTE
The specified tightening torque is also described in the following.
“Starter Motor Components (Page 1I-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
1
I815H1190018-01
Position
Color
PUSH
O/W Y/G O/R
Y/W
I815H1190019-01
Item Specification Note
Starter motor brush length
Standard 12.0 (0.47)
Limit 8.5 (0.33)
Starter torque limiter slip torque Standard
33.3 – 52.0 N⋅m
(3.3 – 5.2 kgf-m, 24.0 – 37.5 lb-ft)
Starter relay resistance 3 – 5 Ω
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Starter motor housing bolt 5 0.5 3.5 )(Page 1I-5)
Starter clutch bolt 55 5.5 40.0 )(Page 1I-11)