Suzuki GSX1300R - Oil Pressure Regulator; Oil Strainer Inspection

1E-7 Engine Lubrication System:
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply grease to the O-rings.
CAUTION
!
Use the new O-rings to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Tighten the oil pan bolts diagonally.
CAUTION
!
• Use the new oil pan gasket to prevent oil
leakage.
• Fit the new gasket washer to the oil pan
bolt (1) to prevent oil leakage.
• Connect the left oil cooler hose to the oil pan. Refer to
“Oil Cooler / Oil Cooler Hose Removal and Installation
(Page 1E-8)”.
• Pour engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)”.
• Install removed parts.
Oil Pressure Regulator / Oil Strainer Inspection
B815H21506004
Refer to “Oil Pan / Oil Strainer / Oil Pressure Regulator
Removal and Installation (Page 1E-6)”.
Oil pressure regulator
Inspect the operation of the oil pressure regulator by
pushing on the piston with a proper bar.
If the piston does not operate, replace the oil pressure
regulator with a new one.
Oil Strainer
Clean the oil strainer if necessary.
Inspect the oil strainer body for damage. If necessary,
replace it with a new one.
I823H1150009-02
I815H1150007-01
1
I815H1150008-01
I718H1150033-01
I823H1150012-01