Steering / Handlebar: 6B-10
• Install the steering damper and tighten the bolt (1) and
nut (2).
Tightening torque
Steering damper bolt (a): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
Steering damper nut (b): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
Inspection after installation
• Check the steering tension. Refer to “Steering Tension
Adjustment (Page 6B-12)”.
Steering Related Parts Inspection
B815H26206008
Refer to “Steering Removal and Installation (Page 6B-
6)”.
Inspect the removed parts for the following
abnormalities:
• Distortion of the steering stem
• Bearing wear or damage
• Abnormal bearing noise
• Race wear or damage
• Bearing lower seal damage
• Rubber seat and damper bushing wear or damage
• Inspect the steering damper body, bearing dust seal
and oil seal for damage and oil leaking.
• Move the steering damper rod by hand to inspect for a
smooth movement.
If any abnormal points are found, replace defective parts
with new ones.
Steering System Inspection
B815H26206009
Refer to “Steering System Inspection in Section 0B
(Page 0B-20)”.
(a)
1
(b)
2
I815H1620028-01
I815H1620029-01
I815H1620030-01
I815H1620031-01
I815H1620032-01
To Next Page
Loading...
