Suzuki GSX1300R - Special Tools and Equipment; Recommended Service Material; Specifications; Service Data

9A-9 Wiring Systems:
Specifications
Service Data
B815H29107001
Electrical
Tightening Torque Specifications
B815H29107002
NOTE
The specified tightening torque is also described in the following.
“Wiring Harness Routing Diagram (Page 9A-5)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B815H29108001
NOTE
Required service material is also described in the following.
“Wiring Harness Routing Diagram (Page 9A-5)”
1. Gear position switch 8. Battery (–) lead wire : 120 N⋅m (12.0 kgf-m, 87 lb-ft)
2. Oil pressure switch “A”: When tightening the starter motor mounting bolts, tighten rear one first. : 10 N⋅m (1.0 kgf-m, 7.0 lb-ft)
3. Starter motor “a”: Within 20° :1.5 N⋅m (0.15 kgf-m, 1.0 lb-ft)
4. CMP sensor “b”: Approx. 30° :14 N⋅m (1.4 kgf-m, 10.0 lb-ft)
5. CKP sensor : 6.5 N⋅m (0.65 kgf-m, 4.7 lb-ft) : 5 N⋅m (0.5 kgf-m, 3.5 lb-ft)
6. Speed sensor : 6 N⋅m (0.6 kgf-m, 4.3 lb-ft) : Apply bond to the thread part.
7. Clamp : 11 N⋅m (1.1 kgf-m, 8.0 lb-ft) : Apply threaded lock to the
threaded part.
Item Specification Note
Fuse size
Headlight
HI 10 A
LO 10 A
Signal 10 A
Ignition 15 A
Fuel 10 A
Fan (LH)
15 A
Fan (RH)
Main 30 A