1B-11 Emission Control Devices:
PAIR System Inspection
B815H21206005
PAIR Hose
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)”.
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)”.
3) Inspect the PAIR hoses (1) for wear or damage. If it
is worn or damaged, replace the PAIR hose with a
new one. Refer to “Exhaust Emission Control
System Description (Page 1B-3)”.
4) Reinstall the removed parts.
PAIR Reed Valve
NOTE
PAIR control solenoid valve can be checked
without removing it from the motorcycle.
Refer to “DTC “C49” (P1656): PAIR Control
Solenoid Valve Circuit Malfunction in Section
1A (Page 1A-108)”.
1) Remove the PAIR reed valves. Refer to “PAIR Reed
Valve Removal and Installation (Page 1B-9)”.
2) Inspect the reed valves for the carbon deposit.
If the carbon deposit is found in the reed valve,
replace the PAIR reed valve with a new one.
3) Reinstall the PAIR reed valves. Refer to “PAIR Reed
Valve Removal and Installation (Page 1B-9)”.
PAIR Control Solenoid Valve
1) Remove the PAIR control solenoid valve. Refer to
“PAIR Control Solenoid Valve Removal and
Installation (Page 1B-10)”.
2) Check that air flows through the air inlet port to the
air outlet port. If air does not flow out, replace the
PAIR control solenoid valve with a new one.
3) Connect the 12 V battery to the PAIR control
solenoid valve terminals and check the air flow. If air
does not flow out, the solenoid valve is in normal
condition.
1
I815H1120015-01
I823H1120013-01
I823H1120014-01
12V
I823H1120015-01
To Next Page
Loading...
