1D-15 Engine Mechanical:
NOTE
• Make sure the throttle valves smoothly
open and close.
• For TP sensor setting procedure, refer to
“TP Sensor Adjustment in Section 1C
(Page 1C-4)”.
• Apply thin coat of engine oil to the new O-rings (3) and
cushion seals (4).
CAUTION
!
Replace the O-rings and cushion seals with
new ones.
• Assemble the fuel delivery pipes as shown in the
figure.
CAUTION
!
Be careful not to twist the fuel delivery pipe
T-joint when installing the fuel delivery pipes,
or joint part “E” of the fuel delivery pipe may
get damage.
• Install each fuel injector by pushing it straight to the
fuel delivery pipe and throttle body.
CAUTION
!
Never turn the injector while pushing it.
• Install the fuel delivery pipe assembly to the throttle
body.
• Tighten the fuel delivery pipe mounting screws (5) to
the specified torque.
Tightening torque
Fuel delivery pipe mounting screw (b): 3.5 N·m (
0.35 kgf-m, 2.5 lb-ft)
I815H1140037-01
4
3
3
4
I823H1140026-01
3
I815H1140038-01
“E”
I815H1140039-01
I815H1140040-02
To Next Page
Loading...
