Suzuki GSX1300R - Page 255

Engine Mechanical: 1D-34
• Place the cylinder head on the cylinder.
NOTE
• When installing the cylinder head, keep the
cam chain taut.
• Apply engine oil to the washers and thread
portion of the bolts before installing the
cylinder head bolts.
• Tighten the cylinder head bolts (M10) to the specified
two-step torque with a torque wrench sequentially and
diagonally.
Tightening torque
Cylinder head bolt (M10) (Initial): 25 N·m (2.5 kgf-
m, 18.0 lb-ft)
Cylinder head bolt (M10) (Final): 52 N·m (5.2 kgf-
m, 37.5 lb-ft)
• After firmly tightening the cylinder head bolts (M10),
install the cylinder head bolts (M6) (3).
• Tighten the cylinder head bolts (3) and the cylinder
nuts (4) to the specified torque.
Tightening torque
Cylinder head bolt (M6) (a): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
Cylinder nut (M6) (b): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the gasket (5) and cylinder head side bolt (6).
Tighten the bolt to the specified torque.
Tightening torque
Cylinder head side bolt (c): 14 N·m (1.4 kgf-m,
10.0 lb-ft)
NOTE
• The metal side “B” of the gasket (5) should
faces outside.
• Install the cylinder head side bolt between
the cam chain.
• Install the oil hose (7).
CAUTION
!
Use new gasket washers to prevent oil
leakage.
I823H1140063-01
I823H1140064-01
(a)
3
(a)
3
(b)
4
I823H1140065-03
“B”
5
(c)
6
I815H1140051-01