Suzuki GSX1300R - Page 354

1F-14 Engine Cooling System:
4) Remove the impeller shaft (5) and washer (6) from
the water pump body.
5) Remove the mechanical seal with the special tool.
NOTE
If there is no abnormal condition, the
mechanical seal removal is not necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
6) Remove the oil seal.
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
Assembly
1) Install the oil seal with the special tool.
CAUTION
!
The removed oil seal must be replaced with a
new one.
NOTE
The stamped mark on the oil seal should face
mechanical seal side.
Special tool
(A): 09913–70210 (Bearing installer set)
2) Apply a small quantity of the grease to the oil seal
lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5
6
I823H1160036-01
(A)
I823H1160037-02
I823H1160038-02
(A)
I823H1160039-01
I823H1160040-01