Charging System: 1J-8
• Install the rotor bolt with the washer.
• Hold the generator rotor with the special tool and
tighten its bolt (3) to the specified torque.
Special tool
(A): 09930–44530 (Rotor holder)
Tightening torque
Generator rotor bolt (c): 120 N·m (12.0 kgf-m, 87.0
lb-ft)
• Apply a bond lightly to the mating surfaces at the
parting line between the upper and lower crankcases
as shown.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
• Install the dowel pins (4) and new gasket (5).
CAUTION
!
Use a new gasket to prevent oil leakage.
• Install the generator cover (6) and tighten the
generator cover bolts.
WARNING
!
Be careful not to pinch the finger between the
generator cover and crankcase.
(A)
(c)
3
I815H11A0011-01
I815H11A0012-01
5
4
4
I815H11A0013-01
6
I815H11A0014-01
To Next Page
Loading...
