0B-12 Maintenance and Lubrication:
5) Install the new oil filter. Turn it by hand until you feel
that the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
(A): 09915–40610 (Oil filter wrench)
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lb-ft)
6) Add new engine oil and check the oil level is as
described in the engine oil replacement procedure.
Necessary amount of engine oil
Oil change: 3 100 ml (3.3/2.7 US/lmp qt)
Oil and filter change: 3 300 ml (3.5/2.9 US/lmp qt)
Engine overhaul: 4 000 ml (4.2/3.5 US/lmp qt)
Throttle Cable Play Inspection and Adjustment
B815H20206009
Inspect throttle cable play
Initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Inspect and adjust the throttle cable play “a” as follows:
Throttle cable play “a”
2.0 – 4.0 mm (0.08 – 0.16 in)
1) Loosen the lock-nut (1) of the throttle pulling cable
(2).
2) Turn the adjuster (3) in or out until the throttle cable
play “a” (at the throttle grip) is between 2 – 4 mm
(0.08 – 0.16 in).
3) Tighten the lock-nut (1) while holding the adjuster
(3).
WARNING
!
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.
Throttle Valve Synchronization
B815H20206010
Inspect throttle valve synchronization
Initially at 1 000 km (600 miles, 2 months) (E-33 only)
and every 12 000 km (7 500 miles, 24 months)
Inspect the throttle valve synchronization periodically.
Refer to “Throttle Valve Synchronization in Section 1D
(Page 1D-16)”.
(a)
(A)
I823H1020041-01
“a”
I815H1020026-01
1
2
3
I815H1020027-01
To Next Page
Loading...
