Front Suspension: 2B-4
9) Install the handlebar holder assembly.
10) Tighten the handlebar holder mounting bolts and
nuts (6).
Tightening torque
Handlebar holder mounting nut (d): 35 N·m (3.5
kgf-m, 25.5 lb-ft)
11) Install the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation in Section
2D (Page 2D-4)”.
NOTE
Before tightening the front axle and front axle
pinch bolts, move the front fork up and down
four or five times.
WARNING
!
After remounting the brake calipers, pump
the brake lever until the pistons push the
pads correctly.
12) Install the body cowlings. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
13) Adjust the headlight beam. Refer to “Headlight Beam
Adjustment in Section 9B (Page 9B-3)”.
(d)
6
I815H1220008-01
(d)
6
I815H1220009-01
I815H1220010-01
To Next Page
Loading...
