2B-11 Front Suspension:
Fork spring
NOTE
The larger diameter “a” should face to the
bottom side of the front fork.
• Install the spring (1), spacer (2) and spring retainer
(3).
Front fork cap bolt
• Adjust the height “a” of the inner rod threads by
turning the lock-nut (1) as shown in the figure.
• Pull up the inner rod with the special tool (A).
• Compress the spring with the special tool (B) and then
insert the special tool (C) between the lock-nut and
spring retainer.
Special tool
(A): 09940–52841 (Inner rod holder)
(B): 09940–94930 (Front fork spacer holder)
(C): 09940–94922 (Front fork spring stopper
plate)
• Make sure that the height “a” of the inner rod threads
after removing the special tool.
• Insert the adjuster rod in to the inner rod.
• Apply fork oil to the O-ring.
CAUTION
!
• Make sure that the rebound damping force
adjuster (1) to the softest position before
installing the cap bolt.
• Use a new O-ring to prevent oil leakage.
: Fork Oil 99000–99044–L01 (SUZUKI FORK
OIL L01 or equivalent)
“a”: 11 mm (0.43 in)
“a”
I815H1220029-01
1
2
3
I815H1220030-01
1
“a”
I823H1220029-02
(A)
(C)
(B)
I823H1220031-02
“a”
I823H1220075-01
1
I815H1220031-01
To Next Page
Loading...
