Drive Chain / Drive Train / Drive Shaft: 3A-3
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Apply thread lock to the driveshaft.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 145 N·m (14.5 kgf-m,
105.0 lb-ft)
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 28 N·m (2.8 kgf-m,
20.0 lb-ft)
• Before installing the engine sprocket cover, apply a
small quantity of grease to the clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket cover (3).
• Tighten the speed sensor mounting bolt (4) to the
specified torque.
Tightening torque
Speed sensor bolt (c): 6.5 N·m (0.65 kgf-m, 4.7 lb-
ft)
• Fit the gearshift link arm to the gearshift shaft so that
the gearshift lever is located at height “a” above the
footrest.
Gearshift lever height “a”
Standard: 50 – 60 mm (2.0 – 2.4 in)
• Adjust the drive chain slack. Refer to “Drive Chain
Inspection and Adjustment in Section 0B (Page 0B-
15)”.
(a)
1
I815H1310007-01
(b)
2
I815H1310008-01
(c)
4
3
I815H1310009-01
“a”
I815H1310010-01
To Next Page
Loading...
