Suzuki GSX1300R - Page 488

3A-6 Drive Chain / Drive Train / Drive Shaft:
4) Remove the sprocket mounting drum bearing using
the special tool.
Special tool
(B): 09921–20240 (Bearing remover set)
Installation
CAUTION
!
The removed dust seal and bearing must be
replaced with new ones.
1) Apply grease to the bearing before installing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
2) Install the bearing (1) and dust seal (2) to the
sprocket mounting drum using the special tools.
CAUTION
!
The sealed cover of the bearing must face
wheel hub side.
Special tool
(A): 09924–84510 (Bearing installer set)
(B): 09913–70210 (Bearing installer set)
3) Apply grease to the dust seal lip.
4) Apply grease to the retainer before installing the rear
sprocket mounting drum.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(B)
I823H1310021-01
I649G1310020-02
(A)
(B)
2
1
I823H1310022-03
I823H1310023-02