Suzuki GSX1300R - Page 529

Rear Brakes: 4C-5
• Apply the brake fluid to piston seal (1) and dust seal
(2).
CAUTION
!
Replace the piston seal (1) and dust seal (2)
with new ones.
BF: Brake fluid (DOT 4)
• Install the piston seal (1) as shown in the figure.
• Apply grease to the inside of the rubber boot.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
• Set the rubber boot to the caliper.
• Install the spacer into the rubber boot.
• Tighten the sliding pin (3) and apply grease to the
sliding pin.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
Tightening torque
Rear brake caliper sliding pin (a): 33 N·m (3.3 kgf-
m, 24.0 lb-ft)
• Set the rubber boot onto the brake caliper and sliding
pin.
• Install the brake caliper to its bracket.
1
2
I649G1420013-02
I823H1430014-01
(a)
3
I823H1430015-01
I823H1430024-01