Suzuki GSX1300R - Page 545

Manual Transmission: 5B-9
NOTE
• Rotate the bearing by hand to inspect if
there is any abnormal noise and for
smooth rotation. Replace the bearing if
there is anything unusual.
• Before installing the gears, apply
molybdenum oil to the driveshaft and
countershaft.
• Before installing the oil seal, apply grease
to the oil seal lip.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• When installing a new snap ring (1), pay attention to
its direction. Fit it to the side where the thrust is as
shown in the figure.
Driveshaft
• Install the driveshaft bearing (1) using a hydraulic
press and special tool.
CAUTION
!
Never reuse driveshaft bearing (1).
Special tool
(A): 09913–70210 (Bearing installer set)
• Install the spacer (2) using a hydraulic press and
special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Press fit the friction ring (3) of the driveshaft with the
special tool until the dimension “a” becomes 4.5 – 4.8
mm (0.18 – 0.19 in).
Special tool
(A): 09913–70210 (Bearing installer set)
“A”: Thrust “B”: Sharp edge
1
“A”
“B”
I649G1520049-02
1
1
(A)
I823H1520022-01
“a”: 4.5 – 4.8 mm (0.18 – 0.19 in)
2
2
(A)
I823H1520023-02
(A)
I823H1520088-01
3
“a”
I823H1520089-02