Suzuki GSX1300R - Page 548

5B-12 Manual Transmission:
Installation
Install the gear position switch in the reverse order of
removal. Pay attention to the following points:
NOTE
Align the gear position switch pin “A” with
the gearshift cam hole “B”.
• Apply a bond lightly to the gear position switch bolt
lead wire grommet (1).
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
NOTE
• The flat surface of the clamp faces the lead
wire.
• After contacting the clamp to the stopper
“C” of the crankcase, tighten the clamp
bolt.
• Be sure to install the grommet (1) to the
crankcase.
Tightening torque
Gear position switch mounting bolt (a): 6.5 N·m (
0.65 kgf-m, 4.7 lb-ft)
Gear position switch lead wire clamp bolt (b): 6.5
N·m (0.65 kgf-m, 4.7 lb-ft)
• Route the gear position switch lead wire. Refer to
“Wiring Harness Routing Diagram in Section 9A
(Page 9A-5)”.
“A”
“B”
I815H1520009-01
“C”
1
I815H1520010-01
(b)
(a)
I815H1520011-01