Suzuki GSX1300R - Page 565

Clutch: 5C-9
6) Remove the piston/cup set from the master cylinder.
• Secondary cup (9)
• Piston (10)
• Primary cup (11)
• Spring (12)
Assembly
Assemble the master cylinder in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Wash the master cylinder components with
new brake fluid before reassembly.
• Do not wipe the clutch fluid off after
washing the components.
• When washing the components, use the
specified clutch fluid (Brake fluid). Never
use different types of fluid or cleaning
solvents such as gasoline, kerosine, etc.
• Apply brake fluid to the master cylinder
bore and to all of the master cylinder
components to be inserted into the bore.
BF: Brake fluid (DOT 4)
• Apply silicone grease to the push rod ends.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
• When installing the clutch lever position switch, align
the projection “A” on the switch with the hole “B” on
the master cylinder.
• Apply silicone grease to the clutch lever pivot bolt.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
Tightening torque
Clutch lever pivot bolt: 1 N·m (0.1 kgf-m, 0.7 lb-ft)
Clutch lever pivot bolt lock-nut: 6 N·m (0.6 kgf-m,
4.5 lb-ft)
9
10
11
12
I815H1530019-01
I815H1530020-01
I815H1530021-01
“A”
“B”
I815H1530022-01
I815H1530023-01