Suzuki GSX1300R - Page 576

5C-20 Clutch:
• Tighten the clutch spring set bolts (16) to the specified
torque.
Tightening torque
Clutch spring set bolt (b): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
NOTE
Tighten the clutch spring set bolt diagonally.
• Apply a bond lightly to the mating surfaces at the
parting line between the upper and lower crankcase
as shown in the figure.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
• Install the gasket (17) and the dowel pins.
CAUTION
!
Use the new gasket to prevent oil leakage.
• Install the cushion (18) and clutch outer cover (19) to
the clutch cover.
(b)
16
I815H1530057-01
I815H1530058-01
17
I815H1530059-01
18
19
I815H1530060-01