DRIVE TRAIN 4-33
BEVEL RING GEAR/SHIM
• Place the removed washer
1 and shim(s)
2 on the gear
case bearing (at the left bearing), then install the ring gear
3
and removed shim(s)
4.
GEAR CASE COVER/GEAR CASE [FINAL ASSEMBLY]
• Coat a new O-ring with grease and apply sealant to the mat-
ing surface of the cover, then install the gear case cover.
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
& 99104-31140: SUZUKI BOND “1207B” (USA)
' 99000-31110: SUZUKI BOND “1215” (Others)
NOTE:
After the backlash and tooth contact have been checked or
adjusted, install a new O-ring and apply sealant.
• Apply THREAD LOCK SUPER “1303” to the case cover bolts
and tighten them to the specified torque in a crisscross pat-
tern.
) 99000-32030: THREAD LOCK SUPER “1303”
( Gear case cover bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
After the backlash and tooth contact have been checked or
adjusted, apply THREAD LOCK SUPER “1303” to the case
cover bolts.
REAR DRIVE SHAFT/ PARKING
• Drive the new bearing into the rear drive shaft housing, then
install the new snap ring into its groove properly.
• Install the oil seal into the rear drive shaft housing.
# 09913-70210: Bearing installer set
To Next Page
Loading...
