CLUTCH 7-7
• Install the push rod and push piece 5.
• Apply engine oil to the release bearing 6.
• Install the release bearing 6 and washer 7.
• Fit the clutch pressure plate 8.
C Direction of outside
• Install the clutch springs and clutch spring set bolts 9.
• Tighten the clutch spring set bolts 9 to the specified torque.
NOTE:
Tighten the clutch spring set bolts 9 diagonally.
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
• Install the gasket 0 and clutch cover A.
• Tighten the clutch cover bolts (A, B) diagonally to the speci-
fied torque.
Clutch cover bolt: 11 N·m (1.1 kgf-m, 8.0 lbf-ft)
A Length: 60 mm (2.4 in)
B Length: 25 mm (1.0 in)
• Install the brake pedal. (17-20)
INSPECTION AFTER INSTALLATION
• Engine oil level and oil leakage (2-12)
• Clutch cable play (2-20)
• Smooth operation of clutch system
Replace the gasket 0 with a new one.
To Next Page
Loading...
