Suzuki RM-Z250 - Installation (Swingarm)

REAR SUSPENSION 19-17
INSTALLATION
Install the swingarm in the reverse order of removal. Pay atten-
tion to the following points:
• Install the following parts into the swingarm.
1 Oil seal 5 Washer
2 Spacer 6 Dust seal
3 Washer 7 Spacer
4 Thrust bearing 8 Washer
• Apply grease to the dust seals, bearings and oil seals.
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Apply a small quantity of THREAD LOCK SUPER to the plate
mounting screws 9.
99000-32110: THREAD LOCK SUPER “1322”
or equivalent
• Tighten the plate mounting screws 9 securely.
• Install the chain buffer.
• Install the swingarm.
• Tighten the swingarm pivot nut 0 to the specified torque.
 Swingarm pivot nut: 70 N·m (7.0 kgf-m, 50.5 lbf-ft)
• Install the cushion lever A and cushion rod B.
• Tighten the cushion lever nut C and cushion rod nut D to the
specified torque.
 Cushion lever nut: 80 N·m (8.0 kgf-m, 58.0 lbf-ft)
Cushion rod nut: 80 N·m (8.0 kgf-m, 58.0 lbf-ft)
• Tighten the master cylinder mounting bolts E to the specified
torque.
 Rear brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lbf-ft)
• Install the chain guide.
• Install the rear wheel. (16-11)
• Adjust the drive chain slack. (2-31)