Suzuki RM-Z250 - Rear Wheel Inspection; Dust Seal and Bearing Replacement (Rear Wheel)

16-8 FRONT AND REAR WHEELS
INSPECTION
WHEEL SPACER
• Remove the wheel spacers from the rear wheel.
• Inspect the rear wheel spacers 1 and dust seals 2 for wear
and cracks.
• If any defects are found, replace the spacer 1 together with
the dust seal 2.
NOTE:
Apply grease on the spacers 1 and dust seals 2 before reas-
sembling.
SPROCKET
• Inspect the sprocket teeth for wear.
• If they are worn as shown, replace the two sprockets and
drive chain as a set.
AXLE SHAFT (16-3)
WHEEL RIM (16-4)
WHEEL BEARING (16-4)
DUST SEAL AND BEARING REPLACEMENT
• Remove the dust seals 1 with the special tool.

 09913-50121: Oil seal remover
• Remove the snap ring 2.

 09900-06108: Snap ring pliers (Close type)
Normal wear
Excessive wear
The removed dust seals 1 must be replaced with new
ones.
The removed snap ring 2 must be replaced with a
new one.