Suzuki RM-Z250 - Brake Lever Removal

FRONT AND REAR BRAKES 17-19
BRAKE LEVER
REMOVAL
• Remove the boot 1.
• Remove the brake lever 3 by removing its bolt and nut 2.
• Remove the brake lever adjuster return spring 5 by removing
its bolt 4 with the special tool.
 09930-11950: Torx wrench (T25H)
INSTALLATION
Install the brake lever in the reverse order of removal. Pay atten-
tion to the following points:
• Apply grease to the brake lever adjuster return spring, pivot
bolt and contact point between piston and brake lever.
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Tighten the brake lever pivot bolt 1 and lock-nut 2 to the
specified torque.
 Brake lever pivot bolt: 6 N·m (0.6 kgf-m, 4.5 lbf-ft)
Brake lever pivot bolt lock-nut:
6 N·m (0.6 kgf-m, 4.5 lbf-ft)