Suzuki RM-Z250 - Dtc and Defective Condition

FI SYSTEM DIAGNOSIS 12-27
DTC AND DEFECTIVE CONDITION
DTC No.
DETECTED
ITEM
DETECTED FAILURE CONDITION CHECK FOR
12
CKP sensor
The signal does not reach ECM for 1
second or more, after receiving the
IAP sensor input signal.
CKP sensor wiring and mechan-
ical parts
CKP sensor, lead wire/coupler
connection
P0335
14
TP sensor
The sensor should produce following
voltage.
0.39 V sensor voltage < 4.51 V
In other than the above range, 14
(P0120) is indicated.
TP sensor, lead wire/coupler
connection
P0120
H
Sensor voltage is higher than specified
value.
TP sensor circuit shorted to
VCC or ground circuit open
L
Sensor voltage is lower than specified
value.
TP sensor circuit open or
shorted to ground or VCC circuit
open
15
ECT sensor
The sensor voltage should be the fol-
lowing.
0.2 V sensor voltage < 4.9 V
In other than the above range, 15
(P0115) is indicated.
ECT sensor, lead wire/coupler
connection
P0115
H
Sensor voltage is higher than specified
value.
ECT sensor circuit open or
ground circuit open
L
Sensor voltage is lower than specified
value.
ECT sensor circuit shorted to
ground
17
IAP sensor
The sensor should produce following
voltage.
0.23 V sensor voltage < 4.11 V
In other than the above range, 17
(P0105) is indicated.
IAP sensor, lead wire/coupler
connection
P0105
H
Sensor voltage is higher than specified
value.
IAP sensor circuit shorted to
VCC or ground circuit open
L
Sensor voltage is lower than specified
value.
IAP sensor circuit open or
shorted to ground or VCC circuit
open
21
IAT sensor
The sensor voltage should be the fol-
lowing.
0.19 V sensor voltage < 4.93 V
In other than the above range, 21
(P0110) is indicated.
IAT sensor, lead wire/coupler
connection
P0110
H
Sensor voltage is higher than specified
value.
IAT sensor circuit open or
ground circuit open
L
Sensor voltage is lower than specified
value.
IAT sensor circuit shorted to
ground