Suzuki RM-Z250 - Rear Master Cylinder Removal and Disassembly

FRONT AND REAR BRAKES 17-17
REAR MASTER CYLINDER REMOVAL AND
DISASSEMBLY
• Drain brake fluid. (17-5)
• Remove the cotter pin 1 and then master cylinder rod pin 2
and washer. (17-18)
• Remove the master cylinder 4 by removing the bolts 3.
• Place a rag under the brake hose union bolt 5 to catch spilled
brake fluid.
• Disconnect the brake hose 6 by removing the union bolt 5.
• Remove the master cylinder.
• Remove the dust boot 7 and snap ring 8.
 09900-06108: Snap ring remover (Close type)
• Remove the push rod 9.
• Remove the piston/cup set 0.