ELECTRICAL SYSTEM 15-13
INSPECTION
IGNITION COIL PRIMARY PEAK VOLTAGE
• Remove the seat, radiator covers and fuel tank.
(5-2, 13-2, -3)
• Hold the cylinder head cover bolt immovable with the wrench.
• Remove the ignition coil retainer 2 by removing its bolts 1.
• Disconnect the ignition coil/plug cap lead wire coupler 3
before removing the ignition coil/plug cap 4.
• Connect a new spark plug 5 to the ignition coil/plug cap 4.
• Connect the ignition coil/plug cap lead wire coupler to the igni-
tion coil/plug cap, and ground it to the cylinder head.
NOTE:
Be sure that the coupler and spark plug are connected properly.
* Do not remove the ignition coil/plug cap before dis-
connection the lead wire coupler, or the lead wire will
be damaged.
* Do not pry up the ignition coil/plug cap with a screw-
driver or a bar to avoid damage.
* Be careful not to drop the ignition coil/plug cap as it
may open or short in a circuit.
Avoid grounding the spark plug and suppling the elec-
trical shock to the cylinder head cover (magnesium
parts) to prevent the magnesium material from dam-
age.
To Next Page
Loading...
