19-20 REAR SUSPENSION
BEARING REPLACEMENT
• Remove the collars, dust seals, washers and spacers.
(19-18)
• Remove the needle roller bearings.
Cushion rod bearing
(One side 32 pieces of needle roller bearing)
Cushion lever bearing
a (33 pieces of needle roller bearing)
b (One side 32 pieces of needle roller bearing)
c (One side 32 pieces of needle roller bearing)
• Remove the needle roller bearing cages
1
and
2
with the
special tool.
09921-20240: Bearing remover set (Remover 20 mm)
• Press fit the new needle roller bearing cages
1
and
2
with
the special tool and a suitable size socket wrench.
09924-84521: Bearing installer set
NOTE:
*Wh
en installing the needle roller bearing cages
1
, the
stamped mark on the bearing must face outside. (
2
: right side)
* Position the needle roller bearing cages by referring to the
illustration of page 19-22.
To Next Page
Loading...
