Suzuki RM-Z250 - Cable Routing

SERVICING INFORMATION 20-21
CABLE ROUTING
1 Throttle cable (Pulling cable) *2
Bind the hot starter cable and wiring harness with the
clamp.
2 Throttle cable (Returning cable) *3 Pass the hot starter cable inside of frame bridge.
3 Hot starter cable *4 Pass the clutch cable between radiator bracket and frame.
4 Clutch cable *5
Pass the overflow hose and wiring harness between radia-
tor hose and frame.
5 Radiator overflow hose *6
Pass the overflow hose between engine mounting lower
bracket.
6 Cable guide *7
Align the matching marks on the clutch cable bracket and
on the clutch cable.
a 2 – 3 mm (0.08 – 0.12 in) *8
Pass the throttle cable, hot starter cable and engine stop
switch lead wire inside of the cable guide.
b 14 – 16 mm (0.55 – 0.63 in) *9
The cable guide must be positioned in parallel with the
frame head with its open end facing upward.
*1
Bind the clutch cable (White protector
position) with the clamp.
*1
*4
*9
*8
*5
*6
*7
*2
*3