14-8 COOLING SYSTEM
WATER PUMP IMPELLER AND WATER PUMP SHAFT
• Hold the water pump shaft 1 with a wrench and remove the
impeller 2.
• Remove the washers (3, 4) and water pump shaft 1.
• Remove the oil seal 5.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
INSPECTION
WATER PUMP IMPELLER AND WATER PUMP SHAFT
• Inspect the water pump impeller and water pump shaft for
damage.
• If necessary, replace the defective parts with a new one.
OIL SEAL
• Visually inspect the oil seal for damage.
• If any defects are found, replace the oil seal with a new one.
To Next Page
Loading...
