Suzuki RM-Z250 - Bearing Replacement (Swingarm)

19-16 REAR SUSPENSION
BEARING, SPACER, DUST SEAL, OIL SEAL
• Inspect the bearings, spacers, dust seals and oil seals for
damage.
• If necessary, replace the defective parts with a new one.
• Insert the spacer into the bearings and inspect them for play
and smooth movement.
• If excessive play is noted, replace the bearing with a new one.
BEARING REPLACEMENT
• Remove the bearings 1 and 2 with the special tool.
 09921-20240: Bearing remover set (Remover 20 mm)
• Press the new bearings 1 and 2 with the suitable socket
wrench and special tool. (19-23)
NOTE:
Wh
en installing the bearings 1 and 2 , the stamped mark on the
bearings must face outside.
 09924-84521: Bearing installer set
A Direction of outside
• Apply grease to the bearings.
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent