Suzuki RM-Z250 - Swingarm Inspection

REAR SUSPENSION 19-15
INSPECTION
PIVOT SHAFT
• Measure the pivot shaft runout with the dial gauge and V
blocks.
• If any the runout exceeds the limit, replace the pivot shaft with
a new one.
 Swingarm pivot shaft runout
Service Limit: 0.3 mm (0.01 in)
 09900-20607: Dial gauge
09900-20701: Dial gauge chuck
09900-21304: V blocks
CHAIN BUFFER AND CHAIN GUIDE
• Inspect the chain buffer 1 and chain guide 2 for damage
and excessive wear.
• If any defects are found, replace the chain buffer or guide with
a new one.
PLATE
• Inspect the plate for damage and excessive bend.
• If any defects are found, replace the plate with a new one.
SWINGARM
• Inspect the swingarm for cracks and damage.
• If any defects are found, replace the swingarm with a new
one.