FRONT AND REAR WHEELS 16-9
• Remove the bearings 3 with the special tool.
• Remove the spacer 4 and bearing 3 with the special tool.
09921-20240: Bearing remover set
• Install new bearings 3 with the special tool, using the suitable
spacer A match for the outside dimension of bearings.
09941-34513: Bearing installer
NOTE:
* Install the left side (sprocket side) bearings first and then the
right side bearing.
* After installing the bearings, inspect the bearings for smooth
movement.
a Clearance
4 Spacer
• Install a new snap ring 2.
NOTE:
Take care not to scratch the sealed bearing by the snap ring pli-
ers when installing the snap ring.
09900-06108: Snap ring remover (Close type)
The removed bearings 3 must be replaced with new
ones.
Left
Right
To Next Page
Loading...
