Suzuki RM-Z250 - Page 169

10-12 TRANSMISSION AND CRANKSHAFT
• Remove the bearing 0 with the special tools.
 09923-74511: Bearing puller
09930-30104: Rotor remover sliding shaft
• Remove the bearing A with the special tools.
 09921-20200: Bearing remover (10 mm)
09930-30104: Rotor remover sliding shaft
• Remove the bearing B.
INSTALLATION
• Press the new bearings with the special tool.
 09913-70210: Bearing installer set
Bearing 1:  52 Attachment
Bearing 2, 8:  40 Attachment
Bearing 3, 6:  62 Attachment
Bearing 4:  32 Attachment
Bearing 5:  47 Attachment
Bearing 7:  42 Attachment
Bearing 9:  15 Attachment
• Press the bearing 0 with the appropriate steel rod.
NOTE:
* Press the bearings (2, 4, 5, 8) into the crankcase, so that
the stamped mark side faces inside of the crankcase.
* Press the bearings (9, 0) into the crankcase, so that the
stamped mark side faces outside of the crankcase.