Suzuki RM-Z250 - Page 180

LUBRICATION SYSTEM 11-5
• Remove the clutch component parts. (7-8)
• Remove the primary drive gear 3.
• Remove the snap ring 4, washer 5 and oil pump idle gear
6.
 09900-06107: Snap ring remover (Open type)
• Remove the oil pump No.1 8 by removing its bolts 7.
• Remove the following parts from the oil pump No.1.
Outer rotor 9
Inner rotor 0
Pin A
Washer B
Oil pump No.1 cover C
Oil pump driven gear shaft D
OIL PUMP No.2
• Drain engine oil. (2-13)
• Remove the gearshift lever. (9-3)
• Remove the magneto cover. (15-17)
• Remove the oil pump No.2 cover 2 by removing its bolts 1.
• Remove the dowel pin 3.
• Remove the oil strainer No.2 5 by removing its bolts 4.
Oil strainer inspection (2-16)