Suzuki RM-Z250 - Page 259

FUEL SYSTEM AND THROTTLE BODY 13-13
• Install a new O-ring 3.

• Install the IAP sensor 4 as shown.
• Apply thin coat of engine oil to new O-ring 5 and cushion seal
6.

• Install the fuel injector 7 by pushing it straight to fuel pipe 8.

NOTE:
Align the coupler A of the injector 7 with groove B of the fuel
pipe 8.
• Install the fuel injector 7 by pushing it straight to the throttle
body.

• Tighten the fuel pipe mounting screws 9 to the specified
torque.
 Fuel pipe mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)
Replace the O-ring 3 with a new one.
Replace the O-ring 5 and cushion seal 6 with new
ones.
Never turn the injector 7 while pushing it.
Never turn the injector 7 while pushing it.