Suzuki RM-Z250 - Page 312

17-10 FRONT AND REAR BRAKES
• Apply THREAD LOCK SUPER to the front brake caliper axle
bolt (bracket) and tighten the bolt to the specified torque.
99000-32130: THREAD LOCK SUPER “1360”
or equivalent
 Front brake caliper axle bolt (bracket):
28 N·m (2.8 kgf-m, 20.0 lbf-ft)
• Install the springs and boots.
• Apply SUZUKI SILICONE GREASE to the caliper axles.
 99000-25100: SUZUKI SILICONE GREASE
or equivalent
• Install the caliper bracket 1.
• Install the brake pads.
• Temporarily tighten the brake pad mounting pin.
• Tighten the caliper mounting bolts 2 to the specified torque.
 Front brake caliper mounting bolt:
26 N·m (2.6 kgf-m, 19.0 lbf-ft)
• Tighten the brake pad mounting pin 3 to the specified torque.
 Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
• Set the brake hose end between the hose stopper A, then
tighten the brake hose union bolt 4 to the specified torque.

 Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Install the pad mounting pin cap.
• Refill brake fluid and bleed air from the brake system.
(17-4)
Replace the seal washers with new ones.