FRONT FORK AND STEERING 18-7
• Clamp the axle holder 3 with a vise. Protect the axle holder
3 with a rag when using a vise.
• Loosen the center bolt 4 completely with a 21 mm socket
wrench.
• Compress the outer tube by hands and install the piston
holder (special tool) between the axle holder 3 bottom and
lock-nut 5.
09910-20115: Piston holder
• Hold the lock-nut 5 with a wrench and remove the center bolt
4.
• Remove the push rod 6.
* Clamping the axle holder 3 too tight can damage it
which will affect riding stability.
* Be careful not to clamp the axle holder 3 too tight.
To Next Page
Loading...
