5-2 ENGINE REMOVAL AND INSTALLATION
ENGINE REMOVAL AND INSTALLATION
REMOVAL
• Drain engine oil. (2-13)
• Drain engine coolant. (14-3)
• Remove the seat 1.
• Remove the radiator covers 2, left and right.
• Remove the right frame cover 3.
• Place the jack under the frame to support the motorcycle.
• Remove the fuel tank bolt 4 and rubber band 5.
• Lift and hold the fuel tank.
• Disconnect the fuel pump coupler 6.
• Place a rag under the fuel hose 7 and disconnect the fuel
hose 7 from the fuel pump.
• Remove the fuel tank assembly.
To prevent the motorcycle from falling, make sure to
support the frame with a jack.
* Be sure to disconnect the fuel hose 7 by hand. Do
not disconnect the fuel hose 7 with any tool.
* When removing the fuel tank, do not leave the fuel
hose 7 on the fuel tank side.
To Next Page
Loading...
