Table 1The graph illustrated is to be considered indicative. The curves produced may undergo variations based on the test
conditions.
5.5.3 Cleaning
Clean the shock absorber externally with a soft detergent. Use compressed air. Be careful that all dirt is
removed. Keep the shock absorber clean and spray it with oil (WD40, CRC 5-56 or equivalent) after washing.
Wipe off excessive oil with a cloth. Do not use strong chemicals, i.e. strong solvents or wheel cleaning
detergents, and/or a hard brush for cleaning as it may discolor and change the appearance of the shocks
surface treatments.
5.5.4 Inspection
Check ball joints for possible excessive play or stiction.
Check the piston shaft for leakage and damage.
Check the shock absorber body for external damage.
5.5.5 Recommended Service Intervals
Every 5000 km
Maintenance and repairs must be carried out at Andreani group.
WARNING
• The damper contains pressurized nitrogen gas (N2). Do not open, service or modify this product.
• This damper was developed and designed exclusively for a specific vehicle model and should only
be installed on the intended vehicle model in its original condition as delivered from the vehicle
manufacturer.
To Next Page
