EasyManua.ls Logo

Tatuus T-421 - General Agreement and Warranty

Tatuus T-421
186 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RELEASE 2.1.0
12
1.3 GENERAL AGREEMENT AND WARRANTY
Tatuus is proud of the quality, success and reputation of their products and is delighted that you have chosen
to use the T421 chassis.
The design of each chassis is the subject of much research and development, technical analysis and detailed
testing. However, as with all motorsport products, it is vital that they are correctly maintained and adjusted
for each individual circumstance. This manual is intended to ensure that you obtain the maximum
performance and reliability from this chassis.
We would stress that after each event or prolonged period of running (suggested to be 5000km) the chassis
should be carefully inspected and stripped as appropriate.
This manual contains mileage recommendations for critical components detailed in section 1.5. If in doubt
please contact our Commercial Department who will advise you or, if necessary, put you in contact with one
of our engineers.
It is important to ensure that all adjustments and tolerances are as specified. The use of parts not supplied
by Tatuus will automatically invalidate any warranty or other liability which would normally be assumed by
Tatuus.
Your attention is drawn in particular to the following statement:
‘Goods intended for motorsport or any related application, or for product development, evaluation or
experimentation are supplied subject to the Customer recognizing that such goods may operate under
extreme loads and conditions and that it is the Customer’s responsibility to ensure that the goods are
correctly inspected, adjusted and maintained at all times to suit the specific conditions in which they may be
used.’
‘Lightweight and weight optimized components are supplied subject to warranty only against manufacturing
defects. It is possible that in certain conditions operating life may be reduced. Similarly, prototype,
experimental or components manufactured to the Customer’s design are supplied subject to warranty only
against manufacturing defects.
Furthermore, such components, by their very nature, are not warranted as to their suitability for use or
performance.’
‘Tatuus shall have no liability to the Customer (other than liability for death or personal injury resulting from
Tatuus’ negligence) for any loss or damage of any nature arising from any breach of any expressed or implied
warranty, term or condition of the contract or from any negligence or breach of statutory or other duty on
the part of Tatuus in connection with the performance or purported performance of or failure to perform
the contract other than as set out in this Condition. In no circumstances shall Tatuus be liable for any claims
for indirect or consequential injury or damage (including loss of profits) arising from any such matters.’

Table of Contents

Related product manuals